Unless otherwise specified by the purchaser, these tolerances apply to the nominal inside diameter, which equals the difference between the nominal outside diameter and twice the nominal wall thickness. If a signature cannot be obtained, we will try to leave the goods in a safe location, but we cannot be held responsible for shortages or damages where goods have not been signed for. Perfectly suited for ducting your Tumble Dryer, Bathroom or Kitchen extractor fan, Hydroponics, In-Line Fans, or Cooker Hoods and other ventilation applications. Reducer, 4mm Blanking Plug, 4mm Equal Elbow, 4mm Equal Tee, 4mm Straight Connector, 6-8mm Reducer, 6mm Blanking Plug, 6mm Equal Elbow, 6mm Equal Tee, 6mm Straight Connector, 8mm Blanking Plug, 8mm Equal Elbow, 8mm Equal Tee, 8mm Straight Connector, G1/4 Male Stud, G1/4 Male Stud Elbow, G1/8 Male Stud, G1/8 Male Stud Elbow, M5x0. male and will fit inside Kair 100mm straight ducting Part: DUCVKC250 without the need for a connector.

6 inch to 4 inch Ventilation Duct Reducer 150mm - 100mm

If you wish to connect this to Kair 150mm Straight Pipe Part: DUCVKC650 you will require a male connector / coupling Part: DUCVKC365. Material: carbon steel to ASTM SA-234 Grade B, Concentric type: weld on, Schedule: 40, Dimensions conform to ASME B16. Deliveries can take place from as earlier as 07:30 right up to 18:00 depending on the courier/haulier and considering local traffic etc.This reducer can be used as a part of a long ductwork run for a variety of purposes including whole house ventilation, passive stack vent, positive input, air conditioning, HVAC, and Heat Recovery Systems. All deliveries should be signed for, and we would politely request that you sign and clearly print your name so that in the unlikely event that there are any discrepancies we will have a person to contact. The dimensions and dimensional tolerances defined in MSS SP-43 are substantially the same as those in ASME B16. Perfectly suited for ducting your Tumble Dryer, Bathroom or Kitchen extractor fan, Hydroponics, In-Line Extract Fans, or Cooker Hood.

Reducers Concentric and Eccentric Pipe Fittings Dimensions Chart, Reducers Concentric and Eccentric

MSS SP-43 only covers stainless steel buttweld fittings made for use with Schedule 5S and 10S pipe and Stub Ends suitable for use with Schedule 40S pipe, as defined in ASME B36.Dimensional tolerances are in millimeters unless otherwise indicated and are equal ± except as noted. Flex Seal Flexible Internal Pushfit Adaptor Coupler for Connecting DN150 to DN100 Pipes Using the Internal Wall.