Cuprinol Anti Slip Decking Stain gives a semi-transparent, matt finish which has been specially formulated for use on all types of timber decking. To avoid difficulties it is good practice to acknowledge how much time you can commit to a project in one straight run and not to attempt too much; Divide the task into hourly chunks and paint the first coat on a section of the project, perhaps one or two sides of the shed. Do not apply in temperatures below 5℃, in damp conditions or if rain is likely before the product has dried. It can also be applied on terracotta, brick and stone, to bring beautiful colours to the rest of the garden. This matt wood paint from the Cuprinol Garden shades range is the perfect choice to refresh your home exterior.

Available in a range of Cuprinol Decking Stain colours, this hard wearing product is not only suitable to use on decking and decking steps, but is also perfect for use in larger commercial decking areas. If you can see any area's that might want an extra coat, get that done before starting another whole phase. It is free-flowing to enable a smooth finish that gets into all the gaps and allows the profile of the wood to be a maintained. If this has been done without success you could cover the area in sodium bicarbonate and leave for 20 mins and then scrub with a brush and warm water.Garden Shades is a water based product, so an application of water and detergent should provisionally be used. On previously stained decking, touch up bare areas and allow to dry before finishing with further coats. Cuprinol Anti-Slip Decking Stain is a water based decking stain that is suitable for use on all softwood and hardwood decking. He’s got mobility issues and uses a frame to walk with so it was important that the decking was non slip as possible.

It can also be applied on terracotta, brick and stone, bringing our beautiful rich colour into the garden.Ensure decked areas are swept with a stiff brush or broom to remove all surface dirt, debris and other surface contaminates.

Before application ensure that your decking area has been swept thoroughly and all dirt and debris has been removed.

On decking previously stained with Cuprinol Anti-Slip Decking Stain, use a wire brush to remove any loose or peeling material and remove any surface contaminates as mentioned above. It will give weather and wear protection to both hardwood and softwood decks, while allowing the character of the wood to show through.

Cuprinol anti slip decking stain can be applied by brush or cuprinol fence and decking power sprayer. Before full application of cuprinol decking stain, we always recommend testing out a small area on your decking surface to ensure you are happy with the products overall adhesion and finish. If using more than one can it is advisable to mix them together in a larger container or finish in a corner before starting a new can. Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. To begin, stir the decking stain thoroughly, and then apply 2-3 coats evenly along the grain, avoiding any overlaps where possible.If wood has been exposed and dried out for a long period of time, this may also draw the more of the product away from the surface and into the wood structure. As Garden Shades often goes on directly to the wood, without a primer, sometimes it will soak deep into the wood and this can create the need for a third coat. If using more than one can, it is advisable to mix them together in a larger container or finish in a corner before starting a new can to ensure colour consistency. Its special pigments ensure a rich colour and allow the natural texture of the woodgrain to shine through.