Mounting accessories connect telescope and mount - be it for a permanent setup or to make quick changes from one instrument to the next possible. Most clamp arms are free to fall down when released forcing you to reset them every time you secure them, but not the Micro Jig Ratchet Clamp.

With any standard 1/2” 14-degree dovetail router bit, you can create your own tracks, eliminating the need for expensive aluminum tracks.

The MatchFit Ratchet Clamp AP boasts an impressive 7-inch clamp capacity and a deep 2-1/2-inch throat depth, accommodating various sizes and types of workpieces. Offers a new means of integrating adjustable clamping into a jig securely and out of the way of blades and bits. It fits all the major brands that other aftermarket track clamps fit, but unlike other clamps, ours has the AP Spring that keeps the clamp arm where you set it during use.

It’s an entire system designed to give you all the functionality of T-track and T-track accessories, at a fraction of the cost. Speed up your workflow with the quick-release trigger, a vital feature of the MatchFit Ratchet Clamp AP. All relevant health and safety practices should be used which are applicable to your country of residence. Continue reading for an explanation of the individual values and you can also see a test report that was done on one of our RVO Horizon 60 OTAs. DIY Dovetail Tracks: With the MatchFit system, you can route your dovetail clamp tracks using a dovetail bit.

The big dovetail clamps provide the connection to telescopes support plates and are useful to create support instruments like side-by-side plates (to support two telescopes in parallel on the same mount) or to allow the precise positioning of the guide rings (to adjust precisely the weight balance), or give the possibility to assemble the Losmandy.