Based on the trailer for Men in Black 3, the neuralyzer design has changed slightly, and the flash is now changed to cyan. We payed extra attention to the domes in either end of the print when sanding, because we wanted them to become as reflective and smooth as possible.

I don't have office parties, I only go to conventions and various costuming events, so I'm not worried about bringing an expensive prop. The holes where the latch is supposed to be attached are perfect for this purpose, since they will not be visible after the latch has been fitted, and are just large enough to fit the pointy end of the sticks.

The ratings/reviews displayed here may not be representative of every listing on this page, or of every review for these listings. The electro bio-mechanical neural transmitting zero synapse re-positioner, more commonly known as the Neuralyzer, or in Agent J's case, 'the flashy-thing,' can now be yours!

We first used a black primer, then a silver paint and finished with a clear coat to give it an extra reflective look, and also to protect the paint. i have lots of sci fi/fantasy toys and models - i almost always pull toys out of their packages so they can be played with -- i do have kids that like to play with dad's "old stuff" from time to time, but the prop replicas are off limits. The layers were probably not completely dry within this time, so we wouldn't have wanted to touch it, but they were dry enough for the paint to look nice. This device is seemingly powered by a unit on his belt, and makes a similar bleeping sound to a dial up connection. I can't get my calipers down into the slider enough to get a measurement for the D shaped hole, but its about 15mm.Sadly there are not too many props from MIB, and next to the paper prop stuff, I like t have more 3-dimensional props. The Neuralyzer was used throughout the Men In Black II film to have characters on the receiving end forget prior events and have either K (Tommy Lee Jones) or J (Will Smith) iterate preferred events back to the character.

Please note that size can vary greatly between different figures, and the above are only estimates based on figures we have seen in the past. That way we could paint this area with the primer we will use for the remaining parts, then mask it with tape before painting the rest of the print with silver metallic paint. The next alternative circuit is the one that we actually used on the bread board in the video at the top.I'Ve seen kids (2 or 3 years old) on convention, playing around with MR lightsabres, and because it'S too big for them, they slide it over the ground. Because this item still in production, we do not know the final weight or dimensions, or even how many boxes there will be. Funny thing about the dials -- even if you DID replace them on toys and make them screen-accurate -- 99% of the time others never SEE them because the dials are facing YOU and not THEM.