XTRONS Double 2 Din Universal Car Stereo Radio Player Mounting Car Cage Head Unit Cage Fitting Kit (14-003A)

After driving around like this for a few days testing the system, I decide to try angling the double din cage and headunit within the new fascia so as not to get so much glare from the sun. I managed to do this and these last few photos are how it looks now. The finished? article. I had fed speaker cables from the boot to the front in anticipation of replacing the door speakers and feeding them from my 4 channel amp, but I don't think that will be necessary. a>

Universal Double Din Fascia Plate Kit

Complete stereo upgrade kit to install a Double DIN aftermarket radio and retain the use of the steering wheel controls in aSAAB 9-3 (2006-2013) vehicle, originally fitted with either the Delphi Grundig head unit or the Fujitsu Ten head unit.

Car Audio Fitting Accessories are sold with limited instructions. Some knowledge of car audio installation is helpful, as in some rare case "modification" is necessary.

Universal Double Din Fascia Kit Extra Info

This interface converts the high level audio output of a new head unit to a low level pre amplified signal which will work with an amplifier. 4 adjustable channels for optimum audio quality, it has a built in ground loop isolator and filters to get the best sound from the amplifier. The Double DIN Mounting kit contains a pair of spring clips and a pair of flat plates in addition to the traditional mounting ‘cage’ and outer trim bezel for the fascia. The spring-clips are sandwiched to either side of the head unit using the flat plates. Screw fixings are supplied. The head-unit will now slide into place within the mounting cage and locate with the spring clips. See the 'Resources' section below if you need more information on how to build the DIN Cage. The outer bezel trim snaps into place around the head unit screen. Firstly, after resetting the system I've lost access to the preloaded detailed maps in the SatNav, after getting intouch with Kenwood, I've found this is a software issue that can only be sorted by returning the unit to Kenwood. This isn't a problem because the unit is being returned due to the second issue.