About this deal
EVO-PLAS TENSOL 12 is not recommended for laminating 'Perspex' sheets, as the absorption of the solvent is likely cause distortions and/or stress crazing. sheet can be used if it is suitably annealed prior to bonding. Tensol 12 must not be used with Perspex ME, Joints will be set sufficiently to be handled after 3 hours but must not be machined for at least 24 hours
EVO-PLAS TENSOL 12 should not be used for outdoor applications and cannot be used with Perspex ME, SW or AG grades. Alternative to Tensol 70. Indasol 7070 Structural Plastic Welder is a two component structural acrylic adhesive designed to bond cast acrylic sheet with a bond strength that should always outperform the substrate. Indasol 7070 Product DetailsOnce the adhesive has set the final bond strength can be increased by heat curing the material. This can
applying the adhesive and assembling the parts. Dispense the adhesive from a small polythene bottle
petroleum ether or white spirit then washed with water. Extruded or machined parts should be annealed ANGLOSOL CEMENT 1200 is a ready-mixed, colourless, solvent based cement.It consists of acrylic polymer and methyl methacrylate monomer dissolved in solvents. Refrigerate the cement for at least 12 hours before use. A domestic refrigerator is suitable (5 - 10�C). If this is not possible, an alternative is to cool the cement containers in cold water - although this is less effective. SW or AG grades and is not suitable for laminating sheets. Typical bond strengths are 24 MPa for a cold